Committed water filtration system developing and producing since 2002
In irrigation system, using three-dimensional filtration of sand, as primary filtration to deal with organic and inorganic impurities in water. Sand filters should be selected once the contents of organic impurities in the water is over 10mg/h.
1.High flow rate with low pressure loss.
2.Modularized setting, compact, with less piping reducing the investment.
3.One or multi-parallel filtration units are available according to the requirement of irrigation project.
The Filtering Process
Filtering with media filters, also known as depth filtration, is done by filtering water through a thick layer of graded particles, called the filter bed. These particles can be sand, gravel or other granular materials. The filtration degree depends on the effective size of the bedding and the water velocity through the filter.
Raw water enters from the filter inlet (1) and percolates through the filter bed (2). Suspended materials come into contact and attach to the media particles. Clean water flows through the filtration nozzles (3) and out of the filter via the outlet valve (4).
The gradual dirt buildup in the filter bed causes an increase in the pressure differential across the filter and when it reaches its maximum design value, a cleaning process should be performed. In automatic media filter installations a pressure differential switch senses the pressure differential and when it reaches a preset value, the self cleaning process begins.
The Cleaning Process
Cleaning is done by backwashing; pressurized water flows in reverse direction - from the nozzles upwards, causing suspension of the filter bed, thus releasing the suspended matter from the bedding. The dirt particles are then washed out of the filter through the back-flush valve. In automatic media filters installations the cleaning process is done by the system's controller. When the pressure differential switch senses that the differential pressure across the system reached a pre-set value, a signal is sent to the flushing controller and the self cleaning process begins.
Complete filtration solutions; Custom designed,manual or automatic backwash systems,
complete with manifolds, valves and controllers
Modularity and flexibility, wide range of vessel types and sizes(diameter 20”-48”) suitable for many filtration applications
High quality corrosion resistance vessels, inside and outside spray coating.
High efficiency; Advanced design for perfect water distribution during filtering and backwashing
All filters are rated to 1.0 Mpa.The water inlet pressure should be 0.2Mpa(Min.)
Various connection types, meeting all international standards.
Meets ISO 9001 standards
Sand filter installation
Sand filter installation